summaryrefslogtreecommitdiffstats
path: root/keyboards/tzarc/djinn/rev2/config.h
blob: 52c909d442a9663e70bbc0ba55fc3c9fae70c45c (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
// Copyright 2018-2022 Nick Brassel (@tzarc)
// SPDX-License-Identifier: GPL-2.0-or-later
#pragma once

// Limit the backlight brightness
#ifndef BACKLIGHT_LIMIT_VAL
#    define BACKLIGHT_LIMIT_VAL 144
#endif // BACKLIGHT_LIMIT_VAL

// Split configuration
#define SPLIT_HAND_PIN B9
#define USB_VBUS_PIN B12
#define SERIAL_USART_DRIVER SD3
#define SERIAL_USART_PIN_SWAP
#define SERIAL_USART_TX_PIN B10
#define SERIAL_USART_TX_PAL_MODE 7
#define SERIAL_USART_RX_PIN B11
#define SERIAL_USART_RX_PAL_MODE 7
#ifndef SERIAL_USART_SPEED
#    define SERIAL_USART_SPEED 1200000
#endif // SERIAL_USART_SPEED
#define SERIAL_USART_FULL_DUPLEX

// RGB configuration
#define RGBLED_NUM 86
#define DRIVER_LED_TOTAL 86
#define RGB_MATRIX_SPLIT \
    { 43, 43 }
#define RGB_POWER_ENABLE_PIN B0
#define RGB_CURR_1500mA_OK_PIN C5
#define RGB_CURR_3000mA_OK_PIN C4

// EEPROM configuration
#define EXTERNAL_EEPROM_SPI_SLAVE_SELECT_PIN B5
#define EXTERNAL_EEPROM_SPI_CLOCK_DIVISOR 8 // (160MHz/8) => 20MHz
#define EXTERNAL_EEPROM_BYTE_COUNT 8192
#define EXTERNAL_EEPROM_PAGE_SIZE 64 // it's FRAM, so it doesn't actually matter, this just sets the RAM buffer size

// External flash config
#define EXTERNAL_FLASH_SPI_MODE 3
#define EXTERNAL_FLASH_SPI_SLAVE_SELECT_PIN A8
#define EXTERNAL_FLASH_SPI_CLOCK_DIVISOR 4    // (160MHz/4) => 40MHz
#define EXTERNAL_FLASH_SIZE (4 * 1024 * 1024) // 32Mb/4MB capacity

// Fault indicators
#define BOARD_POWER_FAULT_PIN C9
#define RGB_POWER_FAULT_PIN C4