blob: be670b9b48b43b35c2da8f570099b4b7230ff71b (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
|
# Set the LFK87 hardware version.
#
# RevA - Green PCB. at90usb1286 Only 3 exist
# RevB - We don't talk about RevB
# RevC - Black PCB. at90usb646 First public release
#
# Set to A or C
LFK_REV = C
ifeq ($(LFK_REV), A)
MCU = at90usb1286
OPT_DEFS += -DBOOTLOADER_SIZE=8192
else
MCU = at90usb646
OPT_DEFS += -DBOOTLOADER_SIZE=4096
endif
OPT_DEFS += -DLFK_TKL_REV_$(LFK_REV)
# Processor frequency.
# This will define a symbol, F_CPU, in all source code files equal to the
# processor frequency in Hz. You can then use this symbol in your source code to
# calculate timings. Do NOT tack on a 'UL' at the end, this will be done
# automatically to create a 32-bit value in your source code.
#
# This will be an integer division of F_USB below, as it is sourced by
# F_USB after it has run through any CPU prescalers. Note that this value
# does not *change* the processor frequency - it should merely be updated to
# reflect the processor speed set externally so that the code can use accurate
# software delays.
F_CPU = 16000000
#
# LUFA specific
#
# Target architecture (see library "Board Types" documentation).
ARCH = AVR8
# Input clock frequency.
# This will define a symbol, F_USB, in all source code files equal to the
# input clock frequency (before any prescaling is performed) in Hz. This value may
# differ from F_CPU if prescaling is used on the latter, and is required as the
# raw input clock is fed directly to the PLL sections of the AVR for high speed
# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
# at the end, this will be done automatically to create a 32-bit value in your
# source code.
#
# If no clock division is performed on the input clock inside the AVR (via the
# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
F_USB = $(F_CPU)
# Interrupt driven control endpoint task(+60)
OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
ifeq ($(strip $(ISSI_ENABLE)), yes)
# TMK_COMMON_DEFS += -DISSI_ENABLE
endif
|
