summaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
-rw-r--r--keyboards/ploopyco/trackball_nano/readme.md6
1 files changed, 3 insertions, 3 deletions
diff --git a/keyboards/ploopyco/trackball_nano/readme.md b/keyboards/ploopyco/trackball_nano/readme.md
index 8a293602a8..a82b3bc711 100644
--- a/keyboards/ploopyco/trackball_nano/readme.md
+++ b/keyboards/ploopyco/trackball_nano/readme.md
@@ -2,7 +2,7 @@
# Ploopy Trackball Nano
-![Ploopyco Trackball Nano](https://www.ploopy.co/uploads/b/113cb4122f867acc306a72a2741c5237a9b1d0db13abfe4e8e394cd466c4a311/_MG_7710_1614037372.jpg)
+![Ploopyco Trackball Nano](https://ploopy.co/wp-content/uploads/2021/06/2.jpg)
It's a DIY, QMK Powered Trackball...Nano!
@@ -28,7 +28,7 @@ Occasionally, new revisions of the PCB will be released. Every board comes with
Match the firmware that you flash onto the board with the designator on the board.
-# Customzing your Ploopy Nano Trackball
+# Customizing your Ploopy Nano Trackball
You can change the DPI/CPI or speed of the trackball by calling `adns_set_cpi` at any time. Additionally, there is a `DPI_CONFIG` macro that will cycle through an array of options for the DPI. This is set to 375, 750, and 1375, but can be changed. 750 is the default.
@@ -51,4 +51,4 @@ When flashing the bootloader, use the following fuse settings:
|----------|-------------|
| Low | `0x5E` |
| High | `0x99` |
-| Extended | `0xC3` | \ No newline at end of file
+| Extended | `0xC3` |