summaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
-rw-r--r--docs/getting_started_make_guide.md2
1 files changed, 1 insertions, 1 deletions
diff --git a/docs/getting_started_make_guide.md b/docs/getting_started_make_guide.md
index 29560b8461..14fadb52c2 100644
--- a/docs/getting_started_make_guide.md
+++ b/docs/getting_started_make_guide.md
@@ -13,7 +13,7 @@ The full syntax of the `make` command is `<keyboard_folder>:<keymap>:<target>`,
The `<target>` means the following
* If no target is given, then it's the same as `all` below
-* `all` compiles as many keyboard/revision/keymap combinations as specified. For example, `make planck/rev4:default:all` will generate a single .hex, while `make planck/rev4:all` will generate a hex for every keymap available to the planck.
+* `all` compiles as many keyboard/revision/keymap combinations as specified. For example, `make planck/rev4:default` will generate a single .hex, while `make planck/rev4:all` will generate a hex for every keymap available to the planck.
* `dfu`, `teensy` or `dfu-util`, compile and upload the firmware to the keyboard. If the compilation fails, then nothing will be uploaded. The programmer to use depends on the keyboard. For most keyboards it's `dfu`, but for ChibiOS keyboards you should use `dfu-util`, and `teensy` for standard Teensys. To find out which command you should use for your keyboard, check the keyboard specific readme.
* **Note**: some operating systems need root access for these commands to work, so in that case you need to run for example `sudo make planck/rev4:default:dfu`.
* `clean`, cleans the build output folders to make sure that everything is built from scratch. Run this before normal compilation if you have some unexplainable problems.