# project specific files SRC = matrix.c \ led.c ## chip/board settings # - the next two should match the directories in # <chibios>/os/hal/ports/$(MCU_FAMILY)/$(MCU_SERIES) # - For Teensies, FAMILY = KINETIS and SERIES is either # KL2x (LC) or K20x (3.0,3.1,3.2). # - For Infinity KB, SERIES = K20x MCU_FAMILY = KINETIS MCU_SERIES = K20x # Linker script to use # - it should exist either in <chibios>/os/common/ports/ARMCMx/compilers/GCC/ld/ # or <this_dir>/ld/ # - NOTE: a custom ld script is needed for EEPROM on Teensy LC # - LDSCRIPT = # - MKL26Z64 for Teensy LC # - MK20DX128 for Teensy 3.0 # - MK20DX256 for Teensy 3.1 and 3.2 # - MK20DX128BLDR4 for Infinity with Kiibohd bootloader # - MK20DX256BLDR8 for Infinity ErgoDox with Kiibohd bootloader MCU_LDSCRIPT = MK20DX256BLDR8 # Startup code to use # - it should exist in <chibios>/os/common/ports/ARMCMx/compilers/GCC/mk/ # - STARTUP = # - kl2x for Teensy LC # - k20x5 for Teensy 3.0 and Infinity KB # - k20x7 for Teensy 3.1 and 3.2 MCU_STARTUP = k20x7 # Board: it should exist either in <chibios>/os/hal/boards/ # or <this_dir>/boards # - BOARD = # - PJRC_TEENSY_LC for Teensy LC # - PJRC_TEENSY_3 for Teensy 3.0 # - PJRC_TEENSY_3_1 for Teensy 3.1 or 3.2 # - MCHCK_K20 for Infinity KB BOARD = PJRC_TEENSY_3_1 # Cortex version # Teensy LC is cortex-m0; Teensy 3.x are cortex-m4 MCU = cortex-m4 # ARM version, CORTEX-M0/M1 are 6, CORTEX-M3/M4/M7 are 7 # I.e. 6 for Teensy LC; 7 for Teensy 3.x ARMV = 7 # Vector table for application # 0x00000000-0x00001000 area is occupied by bootlaoder.*/ # The CORTEX_VTOR... is needed only for MCHCK/Infinity KB #OPT_DEFS = -DCORTEX_VTOR_INIT=0x00001000 OPT_DEFS = # Build Options # comment out to disable the options. # BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration ## (Note that for BOOTMAGIC on Teensy LC you have to use a custom .ld script.) MOUSEKEY_ENABLE = yes # Mouse keys EXTRAKEY_ENABLE = yes # Audio control and System control #CONSOLE_ENABLE = yes # Console for debug COMMAND_ENABLE = yes # Commands for debug and configuration #SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend NKRO_ENABLE = yes # USB Nkey Rollover CUSTOM_MATRIX = yes # Custom matrix file BACKLIGHT_ENABLE = yes VISUALIZER_ENABLE = yes LED_DRIVER = is31fl3731c LED_WIDTH = 16 LED_HEIGHT = 5