# Adding RGB Underglow to the KC60  The KC60 has breakout pins to which one may wire a strip of WS2812-compatible LEDs. By default, the source is set up for 16 LEDs on the F5 breakout pin. See [included image](https://i.imgur.com/TcKL2Sn.jpg) for wiring reference. If you attach a different number of LEDs, configure your source for the correct number of LEDs by adding a `config.h` file alongside your `keymap.c` file, with the following contents: ```c #pragma once #undef RGBLED_NUM #define RGBLED_NUM <number of leds> ``` To enable RGB Underglow, simply add a `rules.mk` file containing `RGBLIGHT_ENABLE = yes` alongside your `keymap.c` file, and compile as normal: ```shell make kc60:<keymap> ``` The [ws2812 keymap](keymaps/ws2812/) may be copied and used as a starting point. RGB Underglow is a fairly large feature, and your firmware may be too large to be flashed with it enabled. Adding `CONSOLE_ENABLE = no` or `COMMAND_ENABLE = no` to your `rules.mk` file will reduce the size of the firmware greatly, and if you don't use either feature, is a very low impact change. ## Reference Images   