# Raise ![](https://cdn.shopify.com/s/files/1/0374/9448/9228/files/Dygma-Raise-Hero2.png) * Keyboard Maintainer: [ibash](https://github.com/ibash) * Hardware Supported: [F411 Blackpill](https://github.com/WeActTC/MiniSTM32F4x1) with the [Dygma Raise](http://www.dygma.com) * Hardware Availability: See below Make example for this keyboard (after setting up your build environment): make handwired/dygma/raise/ansi:default Flashing example for this keyboard: make handwired/dygma/raise/ansi:default:flash See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). ## Hardware QMK does not currently support the [Dygma Neuron](https://dygma.com/products/neuron-black) because QMK does not support SAMD21 which the Neuron has. Instead this code uses a [STM32 Blackpill](https://github.com/WeActTC/MiniSTM32F4x1) to create a Neuron replacement. ## Required Hardware 1. [STM32 Blackpill from WeAct Studio](https://github.com/WeActTC/MiniSTM32F4x1) (via [aliexpress](https://www.aliexpress.com/item/1005001456186625.html) or [adafruit](https://www.adafruit.com/product/4877)). 2. 2x USB-C breakouts (via [keeb](https://keeb.io/collections/diy-parts/products/usb-c-breakout-board) or [adafruit](https://www.adafruit.com/product/4090)). 3. 2x 2.7KΩ resistors (via [digikey](https://www.digikey.com/en/products/detail/yageo/CFR-25JB-52-2K7/684)). 4. Breadboard or PCB proto board, wires, solder, etc. ## Wiring Briefly each raise hand uses I2C to communicate with the Neuron: 1. USB D+ is the I2C clock line. 2. USB D- is the I2C data line. 3. The resistors are pullup resistors for the I2C lines. 4. Each hand draws power from the USB port. ![](https://i.imgur.com/ai9rcHal.png) <p float="left"> <img src="https://i.imgur.com/GvXfnpf.jpg" width="200"> <img src="https://i.imgur.com/kFKFjrU.jpg" width="200"> </p> We are also prototyping a [custom pcb](https://www.reddit.com/r/DygmaLab/comments/ojgm95/pcb_for_running_qmk_on_the_raise/?utm_source=share&utm_medium=web2x&context=3). <p> <img src="https://i.imgur.com/xfzIxkW.png" width="200"> </p>