From 490a13a02e0e247d07644a64f6df7e4ec9a628a3 Mon Sep 17 00:00:00 2001 From: fauxpark Date: Sun, 8 Sep 2019 01:24:19 +1000 Subject: Add 328P to mcu_selection.mk (#6682) --- keyboards/handwired/hnah40/rules.mk | 39 ------------------------------------- 1 file changed, 39 deletions(-) (limited to 'keyboards/handwired/hnah40') diff --git a/keyboards/handwired/hnah40/rules.mk b/keyboards/handwired/hnah40/rules.mk index efd11bfa5c..341b8d03d9 100644 --- a/keyboards/handwired/hnah40/rules.mk +++ b/keyboards/handwired/hnah40/rules.mk @@ -1,42 +1,5 @@ # MCU name MCU = atmega328p -PROTOCOL = VUSB - -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. -F_CPU = 16000000 - - -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Interrupt driven control endpoint task(+60) -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT BOOTLOADER = bootloadHID @@ -69,5 +32,3 @@ BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID AUDIO_ENABLE = no # Audio output on port C6 FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches HD44780_ENABLE = no # Enable support for HD44780 based LCDs (+400) -NO_UART = yes -NO_SUSPEND_POWER_DOWN = yes \ No newline at end of file -- cgit v1.2.3