From b56282756b5faa410301de8c4ecdcae0e0148652 Mon Sep 17 00:00:00 2001 From: Ryan Date: Tue, 14 Sep 2021 22:16:24 +1000 Subject: [Docs] Clean up some code block languages (#14434) --- docs/feature_backlight.md | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-) (limited to 'docs/feature_backlight.md') diff --git a/docs/feature_backlight.md b/docs/feature_backlight.md index d47ecc6824..79782cf564 100644 --- a/docs/feature_backlight.md +++ b/docs/feature_backlight.md @@ -8,7 +8,7 @@ The MCU can only supply so much current to its GPIO pins. Instead of powering th Most keyboards have backlighting enabled by default if they support it, but if it is not working for you, check that your `rules.mk` includes the following: -```makefile +```make BACKLIGHT_ENABLE = yes ``` @@ -54,7 +54,7 @@ If backlight breathing is enabled (see below), the following functions are also To select which driver to use, configure your `rules.mk` with the following: -```makefile +```make BACKLIGHT_DRIVER = software ``` @@ -87,7 +87,7 @@ This functionality is configured at the keyboard level with the `BACKLIGHT_ON_ST The `pwm` driver is configured by default, however the equivalent setting within `rules.mk` would be: -```makefile +```make BACKLIGHT_DRIVER = pwm ``` @@ -143,7 +143,7 @@ The breathing effect is the same as in the hardware PWM implementation. While still in its early stages, ARM backlight support aims to eventually have feature parity with AVR. The `pwm` driver is configured by default, however the equivalent setting within `rules.mk` would be: -```makefile +```make BACKLIGHT_DRIVER = pwm ``` @@ -167,7 +167,7 @@ Currently only hardware PWM is supported, not timer assisted, and does not provi In this mode, PWM is "emulated" while running other keyboard tasks. It offers maximum hardware compatibility without extra platform configuration. The tradeoff is the backlight might jitter when the keyboard is busy. To enable, add this to your `rules.mk`: -```makefile +```make BACKLIGHT_DRIVER = software ``` @@ -188,7 +188,7 @@ To activate multiple backlight pins, add something like this to your `config.h`, If none of the above drivers apply to your board (for example, you are using a separate IC to control the backlight), you can implement a custom backlight driver using this simple API provided by QMK. To enable, add this to your `rules.mk`: -```makefile +```make BACKLIGHT_DRIVER = custom ``` -- cgit v1.2.3