summaryrefslogtreecommitdiffstats
path: root/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
diff options
context:
space:
mode:
Diffstat (limited to 'protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt')
-rw-r--r--protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt30
1 files changed, 0 insertions, 30 deletions
diff --git a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt b/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
deleted file mode 100644
index 6ff1856766..0000000000
--- a/protocol/lufa/LUFA-120730/LUFA/DoxygenPages/ProgrammingApps.txt
+++ /dev/null
@@ -1,30 +0,0 @@
-/** \file
- *
- * This file contains special DoxyGen information for the generation of the main page and other special
- * documentation pages. It is not a project source file.
- */
-
-/** \page Page_ProgrammingApps Programming an Application into a USB AVR
- *
- * Once you have built an application, you will need a way to program in the resulting ".HEX" file (and, if your
- * application uses EEPROM variables with initial values, also a ".EEP" file) into your USB AVR. Normally, the
- * reprogramming of an AVR device must be performed using a special piece of programming hardware, through one of the
- * supported AVR programming protocols - ISP, HVSP, HVPP, JTAG, dW or PDI. This can be done through a custom programmer,
- * a third party programmer, or an official Atmel AVR tool - for more information, see the <a>atmel.com</a> website.
- *
- * Alternatively, you can use the bootloader. From the Atmel factory, each USB AVR comes preloaded with the Atmel
- * DFU (Device Firmware Update) class bootloader, a small piece of AVR firmware which allows the remainder of the
- * AVR to be programmed through a non-standard interface such as the serial USART port, SPI, or (in this case) USB.
- * Bootloaders have the advantage of not requiring any special hardware for programming, and cannot usually be erased
- * or broken without an external programming device. They have disadvantages however; they cannot change the fuses of
- * the AVR (special configuration settings that control the operation of the chip itself) and a small portion of the
- * AVR's FLASH program memory must be reserved to contain the bootloader firmware, and thus cannot be used by the
- * loaded application.
- *
- * If you wish to use the DFU bootloader to program in your application, refer to your DFU programmer's documentation.
- * Atmel provides a free utility called FLIP which is USB AVR compatible, and an open source (Linux compatible)
- * alternative exists called "dfu-programmer".
- *
- * \see \ref Page_BuildModule_DFU for information on the LUFA build system DFU module, for automatic DFU bootloader
- * programming makefile targets.
- */