1 files changed, 6 insertions, 4 deletions
diff --git a/platforms/chibios/drivers/ws2812.c b/platforms/chibios/drivers/ws2812.c
index 7e870661de..1b3bb59842 100644
--- a/platforms/chibios/drivers/ws2812.c
+++ b/platforms/chibios/drivers/ws2812.c
@@ -10,7 +10,7 @@
 #        define NOP_FUDGE 0.4
 #    else
 #        error("NOP_FUDGE configuration required")
-#        define NOP_FUDGE 1  // this just pleases the compile so the above error is easier to spot
+#        define NOP_FUDGE 1 // this just pleases the compile so the above error is easier to spot
 #    endif
 #endif
 
@@ -25,12 +25,12 @@
 // The reset gap can be 6000 ns, but depending on the LED strip it may have to be increased
 // to values like 600000 ns. If it is too small, the pixels will show nothing most of the time.
 #ifndef WS2812_RES
-#    define WS2812_RES (1000 * WS2812_TRST_US)  // Width of the low gap between bits to cause a frame to latch
+#    define WS2812_RES (1000 * WS2812_TRST_US) // Width of the low gap between bits to cause a frame to latch
 #endif
 
 #define NUMBER_NOPS 6
 #define CYCLES_PER_SEC (CPU_CLOCK / NUMBER_NOPS * NOP_FUDGE)
-#define NS_PER_SEC (1000000000L)  // Note that this has to be SIGNED since we want to be able to check for negative values of derivatives
+#define NS_PER_SEC (1000000000L) // Note that this has to be SIGNED since we want to be able to check for negative values of derivatives
 #define NS_PER_CYCLE (NS_PER_SEC / CYCLES_PER_SEC)
 #define NS_TO_CYCLES(n) ((n) / NS_PER_CYCLE)
 
@@ -67,7 +67,9 @@ void sendByte(uint8_t byte) {
     }
 }
 
-void ws2812_init(void) { palSetLineMode(RGB_DI_PIN, WS2812_OUTPUT_MODE); }
+void ws2812_init(void) {
+    palSetLineMode(RGB_DI_PIN, WS2812_OUTPUT_MODE);
+}
 
 // Setleds for standard RGB
 void ws2812_setleds(LED_TYPE *ledarray, uint16_t leds) {