diff options
Diffstat (limited to 'keyboards/kinesis/stapelberg/readme.md')
| -rw-r--r-- | keyboards/kinesis/stapelberg/readme.md | 53 |
1 files changed, 0 insertions, 53 deletions
diff --git a/keyboards/kinesis/stapelberg/readme.md b/keyboards/kinesis/stapelberg/readme.md deleted file mode 100644 index dc6041e5a1..0000000000 --- a/keyboards/kinesis/stapelberg/readme.md +++ /dev/null @@ -1,53 +0,0 @@ -# kinesis_stapelberg keyboard firmware - -This folder contains the firmware customization required to run QMK on the custom controller for the Kinesis Advantage created by Michael Stapelberg. -It differs from the `alvicstep` keyboard in that the existing QMK Kinesis Advantage project uses the existing controller board provided by Kinesis. - -The controller board hardware is described -[here](http://michael.stapelberg.de/Artikel/kinesis_custom_controller) - -Mapping the pin assignments was done using the corresponding matrix description provided at this -[link](https://github.com/stapelberg/kinesis-firmware/blob/master/kb_kinesis/config.kspec) - -This code makes no attempt to drive the four LEDs provided on the controller board. - - -## Building the Hardware - -If you want to perform this customization, these parts may be helpful. - -| Function | Quantity | Vendor | Part Number | -| ------------------------------------------------------ | -------- | ------- | ------------ | -| 13 pin connector for function keys and finger keywells | 4 | Digi-Key | WM14526-ND | -| 10 pin headers for thumb clusters | 4 | Digi-Key | 609-3250-ND | -| 8 pin cable for thumb clusters | 2 | Digi-Key | SAM8928-ND | -| Teensy++ 2.0 | 1 | Digi-Key | 1528-1056-ND | -| 2 pin right angle header for reset | 1 | Digi-Key | 952-2244-ND | -| Reset cables | 1 | Digi-Key | PRT-08672-ND | - -The board and connections are shown here - - -The Teensy mounting detail can be seen here. -I used a socket for prototyping. - - - -Since the proper mounting of the Teensy board places the reset button in a tight space, I added a 2-pin header to the reset and ground pins on the edge of the board. -Shorting these two pins together will reset the board. -I also put female to male header jumper cables on these so they could be accessed outside the enclosure. -The exterior cables can be seen here. - - - -## Keymaps - -### Default - -To build with the default keymap, run `make kinesis/stapelberg` while in the QMK directory. - -### Dvorak - -This keymap contains a dvorak implementation as well as media and symbol layers. - -Run `make kinesis/stapelberg:dvorak` while in the QMK directory. |