diff options
Diffstat (limited to 'keyboards/gingham/rules.mk')
| -rw-r--r-- | keyboards/gingham/rules.mk | 47 |
1 files changed, 0 insertions, 47 deletions
diff --git a/keyboards/gingham/rules.mk b/keyboards/gingham/rules.mk index 83f424ba03..9afbd09644 100644 --- a/keyboards/gingham/rules.mk +++ b/keyboards/gingham/rules.mk @@ -3,42 +3,6 @@ SRC = matrix.c \ # MCU name MCU = atmega328p -PROTOCOL = VUSB - -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. -F_CPU = 16000000 - -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Interrupt driven control endpoint task(+60) -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT # Bootloader selection # Teensy halfkay @@ -51,14 +15,6 @@ OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT # This uses usbaspbootloader BOOTLOADER = USBasp -# If you don't know the bootloader type, then you can specify the -# Boot Section Size in *bytes* by uncommenting out the OPT_DEFS line -# Teensy halfKay 512 -# Teensy++ halfKay 1024 -# Atmel DFU loader 4096 -# LUFA bootloader 4096 -# USBaspLoader 2048 - # Flash program via avrdude, but default command is not suitable. # You can use plaid:default:program PROGRAM_CMD = avrdude -c usbasp -p m328p -U flash:w:$(BUILD_DIR)/$(TARGET).hex @@ -87,7 +43,4 @@ AUDIO_ENABLE = no # Audio output on port C6 FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches HD44780_ENABLE = no # Enable support for HD44780 based LCDs (+400) -# unsupported features for now -NO_UART = yes -NO_SUSPEND_POWER_DOWN = yes CUSTOM_MATRIX = yes |