diff options
Diffstat (limited to 'keyboards/converter/usb_usb')
| -rw-r--r-- | keyboards/converter/usb_usb/rules.mk | 57 |
1 files changed, 10 insertions, 47 deletions
diff --git a/keyboards/converter/usb_usb/rules.mk b/keyboards/converter/usb_usb/rules.mk index dfe89ee7d9..b4f37d3ad8 100644 --- a/keyboards/converter/usb_usb/rules.mk +++ b/keyboards/converter/usb_usb/rules.mk @@ -1,55 +1,16 @@ # MCU name MCU = atmega32u4 -# Processor frequency. -# This will define a symbol, F_CPU, in all source code files equal to the -# processor frequency in Hz. You can then use this symbol in your source code to -# calculate timings. Do NOT tack on a 'UL' at the end, this will be done -# automatically to create a 32-bit value in your source code. -# -# This will be an integer division of F_USB below, as it is sourced by -# F_USB after it has run through any CPU prescalers. Note that this value -# does not *change* the processor frequency - it should merely be updated to -# reflect the processor speed set externally so that the code can use accurate -# software delays. - -# Since there are different hardware variations of these adapters and since these -# have different CPU clocks, the clock speed should be set in the rules.mk file of the -# respective hardware variantion (i.e. subproject). For example, in /pro_micro/rules.mk -# this is set to 8000000. -# The value here is only a fallback and is ignored if it is defined in the subproject. -F_CPU ?= 16000000 - -DEFAULT_FOLDER = converter/usb_usb/hasu - -# -# LUFA specific -# -# Target architecture (see library "Board Types" documentation). -ARCH = AVR8 - -# Input clock frequency. -# This will define a symbol, F_USB, in all source code files equal to the -# input clock frequency (before any prescaling is performed) in Hz. This value may -# differ from F_CPU if prescaling is used on the latter, and is required as the -# raw input clock is fed directly to the PLL sections of the AVR for high speed -# clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' -# at the end, this will be done automatically to create a 32-bit value in your -# source code. -# -# If no clock division is performed on the input clock inside the AVR (via the -# CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. -F_USB = $(F_CPU) - -# Bootloader -# This definition is optional, and if your keyboard supports multiple bootloaders of -# different sizes, comment this out, and the correct address will be loaded -# automatically (+60). See bootloader.mk for all options. +# Bootloader selection +# Teensy halfkay +# Pro Micro caterina +# Atmel DFU atmel-dfu +# LUFA DFU lufa-dfu +# QMK DFU qmk-dfu +# ATmega32A bootloadHID +# ATmega328P USBasp BOOTLOADER = caterina -# Interrupt driven control endpoint task -OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT - # Build Options # comment out to disable the options. # @@ -65,3 +26,5 @@ USB_HID_ENABLE = yes CUSTOM_MATRIX = yes SRC = custom_matrix.cpp + +DEFAULT_FOLDER = converter/usb_usb/hasu |