diff options
Diffstat (limited to 'keyboards/acheron/elongate/beta/readme.md')
| -rwxr-xr-x | keyboards/acheron/elongate/beta/readme.md | 43 |
1 files changed, 0 insertions, 43 deletions
diff --git a/keyboards/acheron/elongate/beta/readme.md b/keyboards/acheron/elongate/beta/readme.md deleted file mode 100755 index d4298254b5..0000000000 --- a/keyboards/acheron/elongate/beta/readme.md +++ /dev/null @@ -1,43 +0,0 @@ -# Acheron Elongate rev. Beta QMK firmware repository - - - -* Keyboard Maintainer: [Gondolindrim](https://github.com/Gondolindrim) -* Hardware Supported: [open-source PCB](https://github.com/AcheronProject/Elongate) powered by STM32F072 microcontroller -* Hardware Availability: the revision beta of Elongate was never publicly sold. - -## Introduction - -This is the QMK firmware repository for the Elongate PCB revision Beta and pre-revision Beta versions, which was the initial revision PCB for this keyboard; hence it was never sold publicly. - -The Elongate PCB is an Open-Hardware-guideline-compliant PCB which files can be found at [this repository](https://github.com/AcheronProject/Elongate). Its designer and maintainer is [Gondolindrim](https://github.com/Gondolindrim). - -## How to flash - -### Enter bootloader - -The DFU state in the bootloader can be accessed in 3 ways: - -* **Bootmagic reset**: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard -* **Physical reset button**: press the button on the front of the PCB. -* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available. - -## Compile firmware - -You can build the default layout firwmare for Elongate after setting up your build environment by using: - - make acheron/elongate/beta:default - -After entering DFU state in your PCB, you can download the binary file generated through `dfu-util` or a GUI like QMK Toolbox. - -To directly flash the PCB after it is put into a DFU state, use - - make acheron/elongate/beta:default:flash - -See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). - -## PCB Documentation - -See the [AcheronDocs](https://acheronproject.com/pcbs/elongate/) page for the ElongatePCB full documentation. You can also check the KiCad PCB files at the [Elongate GitHub repository](https://github.com/AcheronProject/Elongate). - -Before using the files for personal or commercial use, please read the [Acheron Open-Hardware License V1.4](https://acheronproject.com/AOHL14/) under which the Elongate PCB is published. |