diff options
Diffstat (limited to 'keyboards/40percentclub/polyandry/readme.md')
| -rw-r--r-- | keyboards/40percentclub/polyandry/readme.md | 53 |
1 files changed, 0 insertions, 53 deletions
diff --git a/keyboards/40percentclub/polyandry/readme.md b/keyboards/40percentclub/polyandry/readme.md deleted file mode 100644 index 6162bea7a3..0000000000 --- a/keyboards/40percentclub/polyandry/readme.md +++ /dev/null @@ -1,53 +0,0 @@ -# Polyandry/polypad - - -=== - -3x4/4x3 grid layout, multiple controllers supported -- Pro Micro -- PJRC Teensy 2.0 - -(**The below are not currently ported:**) - -- PJRC Teensy LC/3.2 -- PJRC Teensy 3.5/3.6 -- Adafruit ItsyBitsy ATMega32u4 -- Adafruit ItsyBitsy M0 -- Adafruit ItsyBitsy M4 - -The matrix is electrically 1x12 with no diodes, with a thirteenth pin used for the column rather than a ground in order to be compatible with all the listed microcontrollers.. - -The default keymap is a testing keymap that is intended to make sure all of the keys on the matrix are working and properly assigned. - -[The original (minimal arduino sketch) firmware, with support for some unsupported controllers](https://git.40percent.club/di0ib/Misc/src/branch/master/polyandry) - -Keyboard Maintainer: QMK Community -Hardware Supported: Polyandry PCB -Hardware Availability: [Polyandry gerbers are on 40percent.club](https://www.40percent.club/2019/07/polyandry.html) - -Make example for this keyboard (after setting up your build environment): - - make 40percentclub/polyandry:default - or - qmk compile -kb 40percentclub/polyandry -km default - -Default firmware is for an Arduino Pro Micro knockoff. - -If you would like to specify a controller: - - make 40percentclub/polyandry/promicro:default - or - qmk compile -kb 40percentclub/polyandry/promicro -km default - make 40percentclub/polyandry/teensy2:default - or - qmk compile -kb 40percentclub/polyandry/teensy2 -km default - -## Bootloader - -Enter the bootloader in 3 ways: - -* **Bootmagic reset**: Hold down the top left key of the keyboard (top right or bottom left in horizontal configuration) -* **Physical reset**: Briefly press the button on the bottom of the microcontroller or, if not present short the pin marked RST to a GND. -* **Keycode in layout**: Press the key mapped to `QK_BOOT` if it is available - -See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs). |